120 ohm Termination Resistor

There is a permanent 120 ohm termination resistor soldered to the board, no need to add a jumper to enable it and also no ability to disable it.

DFU Mode

To put the Monster8 into DFU mode, hold the BOOT0 button and while still holding press and release the RESET button. Then count to 5 and release the BOOT0 button.

image

Katapult Config

image

Klipper USB-CAN-Bridge Config

image

NOTE ON ENABLING CAN

Make sure to have the CAN select jumper installed. The two jumpers should be on the LEFT and MIDDLE pins.

image