Enable Klipper CAN mode

Have the top switch in the “down” position, and the bottom switch in the “right” position to enable CAN mode.

image

120 ohm Termination Resistor

Set the DIP switch to the ON (Up) position to enable the 120 ohm termination resistor

image

BOOT Mode

To enter BOOT mode, unplug USB and XT30 cables from the SHT36v3, then hold the BOOT button while plugging in the USB-C cable

image

Katapult Config

image

Klipper Config

image

Sample Configuration

A sample config file can be found at https://mellow.klipper.cn/#/board/fly_sht36_v3/cfg

More Info

https://mellow.klipper.cn/#/board/fly_sht36_v3/README